ISY-99i/ISY-26 INSTEON:ELK Configuration

From Universal Devices, Inc. Wiki
Revision as of 18:55, 10 January 2010 by Rand (Talk | contribs) (ELK Configuration)

Jump to: navigation, search

ELK Configuration

Elk Configuration

Enter the IP Address, Port (2101), and Security Code to communicate with the ELK.

Disable All On/Off When checked will ignore X10 All On/Off from ELK.

Be sure to press the Save button after making any changes.

Generate ELK Export File Creates a list of all devices and scenes in a format that the ELK can understand. You will be presented with a save file requester. A new file must be created and imported to the Elk whenever you add or delete devices/scenes.


  • You need ELK M1 Gold + ELK M1 XEP.
  • Make sure you enable the non-secure port for your ELK (2101) and use it in ISY.
  • If you have more than 256 nodes/scenes, then you are going to run out of room in ELK.
  • Please make sure not to use any special characters in the name of your devices.
  • Please use the latest Elk firmware (5.1.14), as previous firmware versions have been known to cause issues.
  • Please check all the Opt flags for all your INSTEON imported devices. This is done in ELK RP|Lighting panel. If you do not have these flags set, you will experience lights intermittently turning on/off by themselves.
  • To make secondary switches and keypad buttons correspond to a device status:
    • Create a scene with all the responders. Do not include the load device.
    • Create a program that controls that scene in response to changes in the load device.

ISY-99i/ISY-26 INSTEON:Configuration Tab

ISY-26 INSTEON / ISY-99i Series INSTEON : User Guide