ISY-99i/ISY-26 INSTEON:Program Summary Tab
- The Name column contains the program names created in the Program Detail tab.
- The Enable column defines whether the program is ON or OFF. When set to OFF, the program is stopped from acting on any stimulus that starts the program. When set to ON, it allows the program to act on the stimulus to start it.
- The Activity column represents the program process. The program states are; Idle, Running ‘Then’ and Running ‘Else’. Idle state, is when the program is running and is waiting for the stimulus to occur. It will also show Running ‘Then’ and Running ‘Else’ messages. These messages are momentarily shown as the program enters and exits the Then or Else statements within the program.
- The Status column presents you with the program state. You will only be presented a True or False state in the column.
- The Path column shows the program location in the program detail tab. Refer to 8.
- Last Run Time and Last Finish Time columns are a time log or time stamp of when the program started and ended.
Pull Down Menu and Apply Button
The pull down menu has a selection of Enable, Disable, Run, Run Else, Stop, Run at Boot and Not Run at Boot. These are actionable commands that are entered in the applicable Enable or Run at Boot column.
- Enable – enables the program to run
- Disable – disables the program so that it will not ever run unless enabled
- Run – runs the program regardless of the condition
- Run Else – runs the Else block of the program
- Stop – Stops the program if currently running
- Run at Boot – whenever the system is rebooted, this program runs regardless of the condition
To enter the command in the enabled column:
- Select the command in the pull down menu.
- Select a program row in the table. Move the mouse pointer to the row and press the left mouse button.
- Select the Apply button.
When a program row is on the table is highlighted and the Edit button is selected, the system will immediately jump to program detail screen showing you the code of the program selected. Refer to Figure 43 for a sample of the program detail screen.
The refresh button updates the summary table if you feel the table is not up to date.