ISY994i:INSTEON Device:FanLinc-KPL FanLinc KeypadLinc Configuration

Setting up a Fanlinc(FL) and 6 button Keypadlinc(KPL) to control a fan

• Add the FL and KPL to your Network
• Remove any existing FL/KPL related scenes
• Select the KPL in the network tree
• Click Button Toggle Mode and make all buttons Non Toggle On
• Click Button Grouping
  • Click Reset button
  • 'Do not ever go back to Button Grouping dialog again. Ever!
• Create 4 Scenes Labeled
  • Name the A button “High”
  • Name the B button “Medium”
  • Name the C button “Low”
  • Name the D button “Off”
• Add the FL - motor device and all 4 KPL buttons to each scene as Follows
  • Off Scene
    • Set the OFF button as Controller
    • Set all other buttons as Responders
    • The FL - Motor will be automatically set as a Responder
  • High Scene
    • Set the High button as Controller
    • Set all other buttons as Responders
    • The FL - Motor will be automatically set as a Responder
  • Medium Scene
    • Set the Medium button as Controller
    • Set all other buttons as Responders
    • The FL - Motor will be automatically set as a Responder
  • Low Scene
    • Set the Low button as Controller
    • Set all other buttons as Responders
    • The FL - Motor will be automatically set as a Responder
• Configure the 4 scenes as follows
  • High Scene
    • Select the High Scene in the network tree
    • Using the sliders in the panel, set the levels for each button and the FL - Motor for this scene
      • High Button – 100
      • Fanlinc - High
      • All other buttons – 0
    • Select the Scene Controller button in the High scene. This entry will be red.
      • Click on Copy Scene Attributes from High
  • Medium Scene
    • Select the Medium Scene in the network tree
    • Using the sliders in the panel, set the levels for each button and the FL - Motor for this scene
      • Medium Button – 100
      • Fanlinc - Med
      • All other buttons – 0
    • Select the Scene Controller button in the Medium scene. This entry will be red.
      • Click on Copy Scene Attributes from Medium
  • Low Scene
    • Select the Low Scene in the network tree
    • Using the sliders in the panel, set the levels for each button and the FL - Motor for this scene
      • Low Button – 100
      • Fanlinc - Low
      • All other buttons – 0
    • Select the Scene Controller button in the Low scene. This entry will be red.
      • Click on Copy Scene Attributes from Low
  • Off Scene
    • Select the Off Scene in the network tree
    • Using the sliders in the panel, set the levels for each button and the FL - Motor for this scene
      • Off Button – 100
      • Fanlinc - Off
      • All other buttons - 0
    • Select the Scene Controller button in the Off scene. This entry will be red.
      • Click on Copy Scene Attributes from Off