Welcome to our Polisy corner: your one place for anything Polisy!
Installation is quite easy - Connect one of the included Cat5e cable to Polisy’s Network Port and to your network hub. You must use the port that’s closest to the right most edge of Polisy when the front of Polisy is facing you. Note: the network must initially be DHCP enabled - If you have the PRO version, attach the included antennas to the back of the unit - Connect the power supply Note: once Polisy is up and running, it will automatically look for your ISY on the network. As such, it's best to make sure your Polisy and your ISY are on the same network.
First Every Bootup Sequence
If this is Polisy's first bootup, please be patient as polisy will go through an initial sequence of lights and sounds while it prepares itself for you. This process might take up to 2 minutes: - All three lights on the front light up when powered on - After a few seconds, only the left most stays lit for up to a minute - All three lights start blinking and a beeping sequence starts - The beeping stops within 25 seconds - Everything is operational once only the left most light is lit
Normal Bootup Sequence
- All three lights on the front light up when powered on - After a few seconds, only the left most stays lit for up to a minute - All three lights start blinking and a beeping sequence starts which lasts about 5 seconds - Everything is operational once only the left most light is lit
If you have a modern router, Polisy advertises itself as polisy on your network. As such, and in most cases, simply open your browser to https://polisy. You will be prompted with a security warning by your browser because polisy uses a self-signed certificate. Please ignore the warning.
You are then presented with the login screen. The default username is admin and default password is admin. Please make sure you change your default username/password once you login.
And that's it!
If you are having a hard time finding your Polisy using https://polisy, it's best to check your router's DHCP client list and look for a device that has the same MAC address as the one the label at the bottom of your Polisy. Polisy's MAC address starts with 00:0d:b9.