ISY-99i/ISY-26 INSTEON:Linking a Trigger Link

TriggerLinc Linking

The Insteon TriggerLinc cannot be linked using Auto Discover.

• Menu - Link Management/New INSTEON device
• Enter the address.
  • The TriggerLinc address is on a sticker inside the battery compartment.
• Select the TriggerLinc [10.02] from the drop down list.
• Click Ok.
• Press and Hold the Set button for 5 seconds to put the TriggerLinc in linking mode as per the requester.

Press and Hold the Set button for 5 seconds

• Click OK.
• Wait while the ISY initializes communications with the TriggerLinc.

2421_Manual

TriggerLinc FAQs

• To access the TriggerLinc, one or more Access Points must be installed.
  • Tip: Plug an Access Point into the PLM for positive results.
• The Set button toggles between Off and On.
• The TriggerLinc must be “awake” to hear messages.
  • Tip: Put the TriggerLinc into linking mode to keep it awake for 4 minutes.
  • The TriggerLinc can be taken out of linking mode by pressing the Set button twice.

---

ISY-26 INSTEON / ISY-99i Series INSTEON : How-To Guide

ISY-99i/ISY-26 INSTEON:Link Management Menu